Step

Omni-Step

Manual or
with 12v Motor

All Omnistep have galvanised frames. The step is produced in anodised aluminium with safe rounded edges. For the new steps, the side plates are in anodised aluminium and the end caps are fluorescent, so that they can be spotted easily in the dark. Both manual and electrical versions meet the European EM1646 standard.

A relay switch for connection to a warning light in the vehicle is supplied as standard. Our company does not accept liability for the non-functioning of this switch. Bearing surfaces are maintenance free.
Omnistep Manual - These steps are pulled out and pushed in
by hand.

Omnistep 12v - Step is operated by a switch. the 12v motor
meets CE standard

Step Edges

For your safety the Omnistep edges are rounded and fluorescent in the dark. Danger of slipping is avoided because the step is in ribbed aluminium.
   
Optional  
Relais - the step is retracted when starting the engine.

Electronic - kit to have the step operate by door contact -
the step is also retracted when starting the engine.


Omni Step Manual 47

Omni Step Manual 550 ALU

OmniStep 12v 460 & 550 ALU
Omni-Step Manual 47 Onmi-Step Manual 550 ALU Omni-Step 12v 460 & 550 ALU

Layout 47

Layout 550 ALU

Layout 12v


Both current and new developments regarding our products are continuously tested.

Testing Equipment

European EN1646 Standard

The required demands do largely surpass the European EN1646 standard.

 

Slide Out ALU Step

  

440 and 500 ALU Step
Omni-Step Slide out ALU   Omni-Step 12v 440 & 500 ALU

Slide Out Mounting Kit

Also for the Omni Step Double are both footboards and side plates manufactured in anodised aluminium.

The synthetic corners give light in the dark.

For improved strength, this step has double profiles on both sides.

440 and 500 ALU Mounting Kit